BLOOD REMOVAL

• Mix High Power WS Pre-Spray at a ratio of 30ml per litre of water.

• Apply the mixed solution directly onto heavy or visibly stained areas.

• Allow a short dwell period, then extract using High Power WS Neutraliser (Acidic Rinse) mixed at 30ml per 10 litres of clean water.

• Repeat this process as required until the worst contamination is removed.
  
  Allow the pre-spray to dwell for approximately 15 minutes to effectively break down remaining residues.

• Once the dwell period is complete, agitate the carpet fibres.

• Mix High Power WS Neutraliser (Acidic Rinse) at 30ml per 10 litres of clean water.

• Rinse extract the entire treated area thoroughly

Optional:
For deeper contamination or blood penetration into the underlay, use a water claw tool to draw out moisture and staining from below the carpet surface.