POLYAMIDE MEDIUM SOILED AREA GUIDE

Step 1: Pre-Vacuuming

• Pre-vacuum the carpet thoroughly to remove loose dirt and debris.

Step 2: Prepare Pre-Spray Solution

• Mix High Power WS Pre-Spray at 30ml per litre of water.

Step 3: Apply Pre-Spray

• Apply a liberal amount of pre-spray to the carpet using overlapping passes.

• Allow the solution to dwell for 15 minutes, during which it will break down soils and deodorise the carpet.

Step 4: Agitation (Optional)

• For heavily soiled areas, use manual or mechanical scrubbing to further lift embedded dirt.

Step 5: Rinse Extraction

• Prepare your rinse solution by mixing WS Stain Repel Rinse at 30ml per 10 litres of clean water.

• Rinse extract the carpet carefully and methodically using your extraction wand.

Tip: For every wet pass, follow with at least seven dry passes.
Maintain uniform, straight wand passes — avoid zig-zagging to prevent pile distortion or “shark’s teeth,” which can become permanent in polyamide carpets.

Step 6: Spot Treatment

• Any remaining stains can be treated with a suitable spot cleaning product.

• Refer to the Spotting Guide for detailed instructions and product selection.

Step 7: Deodorisation

• High Power WS Pre-Spray effectively deodorises polyamide carpets during cleaning.

• For enhanced results, a deodoriser may be added to the rinse tank or lightly sprayed over the carpet after extraction.